ZUZUAN2-Piece 32-Blade Feeler Gauge and 16-Blade Offset Feeler Gauge Set,Dual Marked SAE & Metric Sizes Gauge,Precisely Measure Mechanical Clearances

Could be marked darker

These feeler gages are all almost 1/2 size larger than spec'd. The .004 is .0044, the .008 is .0083, etc. As long as you know these are "plus" gauges - you'll do fine.Work well, and are very consistently "plus" sized, so they are good to use. A Good value.

As described

It’s made well however the etched sizing on both is pretty bad.

These are ok but what is the deal with the numbers. These tools are for doing precise measurements. Why are the numbers silver on silver . I have yet to see gauges with numbers you can read.

What I needed most was to replace a lost angled feeler gage. There was 0.005 and 0.006 but no 0.004. The stainless steel seems not as tough, as I slipped it in and out, it seem to mark up the gages, but I will know better when I use it a couple of times. I am not thrilled with the nut and bolt that holds in the feeler gages in place, but it wasnt expensive.

I sampled a few of these with my old school micrometer and they are within .0005" of spec. Close enough for guitars, cars and country western. Good value.

I purchased these to replace my old craftsman ones that gotten stained with something and hard to read. I liked the angled gauge as I was also replacing a lawn mower ignition coil and it was a tight space for the straight blade to fit in.